Error E6 in Electrolux kitchen plate

Error E6 in Electrolux kitchen plate

How to delete the E6 error in Electrolux cooking plate?

Error: E6
Description: Defect error Induction module.
Cause: Fault in the induction module or related circuitry.
Solution: Check the circuit and capacitors, then replace the module if necessary.

Troubleshooting steps

• First, verify that the connection to the power supply is correctly established and that the fuse is not blown.
• Check that the plug is not damaged and the power source is stable.
• If the electrical connections and fuse are fine, inspect the induction module and related circuit components such as capacitors.
• If a fault is found in the module or circuit, replace the induction module to resolve the error.
• Should the problem persist after these checks, the issue might be in the motherboard of the appliance. In this case, it is recommended to contact a technical or specialist service.

Additional tips

One of the most common problems with Electrolux dishwashers (related appliances) is water not draining correctly. If your dishwasher does not drain properly:

• Check that the drain hose is not bent or obstructed.
• If the hose is clean, the problem could be in the drain pump.
• If the drain pump is faulty, it will need to be replaced.

Other error codes in Electrolux kitchen plate

For more information on other error codes, please refer to the related Electrolux kitchen plate errors listed below.

[pt_view id=”74b76b4vxl” cat=”kitchen-plate,electrolux-en” operator=”AND”]