Error 8C in Samsung washing machine

How to eliminate the 8C error in Samsung washing machine?

• Error: 8C
• Description: The MEMS sensor is not functioning properly.
• Cause: The MEMS RPS sensor has experienced a failure and needs to be replaced.
• Solution:
  • Turn off the washing machine and restart the cycle.
  • Replace the sensor.

If you’ve encountered error code 8C on your device, it indicates an issue with the MEMS RPS sensor connected to the stator motor. It’s important to note that this problem cannot be resolved by simply restarting the system. Below, we’ll guide you through the necessary steps to address this issue and restore your device to normal operation.

Steps to Resolve the Issue

Step 1: Accessing the Sensor

To begin, you’ll need to access the MEMS RPS sensor attached to the stator motor beneath the tub.

Step 2: Removing the Motor

Carefully remove the motor from its location beneath the tub. This will allow for more effective access to the sensor.

Step 3: Disconnecting the Sensor

Locate the sensor on the control board at the back of the device. Disconnect it carefully.

Step 4: Sensor Replacement

Once the sensor is disconnected, it’s time to proceed with its replacement. Acquire a new MEMS RPS sensor that is compatible with your specific model. Be sure to verify the specifications before purchase.

Step 5: Installing the New Sensor

With the new sensor in hand, connect it in the same location where you removed the old one.

Verification and Testing

Before fully reassembling the device, ensure that the sensor is properly connected. Then, perform a test to confirm that the issue has been resolved.

Final Considerations

It’s important to note that the cost of a new MEMS RPS sensor may vary depending on the exact model of your device.

Other error codes in Samsung washing machine

[pt_view id=”74b76b4vxl” cat=”washing-machine,samsung-en” operator=”AND”]